Mapei · Stain protectorNo. 09 / 47
UltraCare Stain Protector W Plus
Water-based, natural effect sealer with oil, stain and water resistant properties.
Water-based, natural effect sealer with oil, stain, water resistant properties
- UltraCare Stain Protector W Plus is used for stain-resistant treatment of natural stone, marble and granite (including with polished finish), brickwork, cementine tiles and engineered stone, both in internal and external surroundings
- The product reduces the amount of water, oil and grease absorbed by the surfaces, making them easier to maintain and clean
- It is suitable for application on food contact surfaces and can be used on floors and coatings, work surfaces, kitchen tops and bathrooms
- Consumption
- About 30 m² per litre, one coat
- Pack we stock
- 1 litre
Coverage calculator
How much you need.
The arithmetic uses Mapei's published consumption for UltraCare Stain Protector W Plus and the pack sizes we stock. Set your own wastage allowance.
You need
x 1 litre jerrycan
- Data sheet quantity
- 0.67 litres
- With 10% wastage
- 0.73 litres
The figures behind it.
- 30 m2 of surface using 1 litre of UltraCare Stain Protector W Plus (one coat), according to the absorption level and surface finish of the material.
Consumption on site depends on the substrate, the tool and the applicator, which is why wastage is yours to set. The result is a quantity to plan and quote with, not a guarantee of coverage. Confirm the system against the current Mapei technical data sheet before ordering.
Application
Where it is used.
In Mapei's own words, from the technical data sheet.
- 01UltraCare Stain Protector W Plus is used for stain-resistant treatment of natural stone, marble and granite (including with polished finish), brickwork, cementine tiles and engineered stone, both in internal and external surroundings
- 02The product reduces the amount of water, oil and grease absorbed by the surfaces, making them easier to maintain and clean
- 03It is suitable for application on food contact surfaces and can be used on floors and coatings, work surfaces, kitchen tops and bathrooms
Where it is not the right product.
- Do not apply the product on surfaces exposed to direct sunlight or if rain is forecast within the next few hours after application
- Avoid application on very cold or very hot surfaces (below +5 °C or above +35 °C)
Specification
Technical data.
- EMICODE · EC1 Plus - very low emissions
- Consistency
- homogeneous liquid
- Colour
- colourless
- pH (at +20°C) neat product
- 7.5
- Density at +20°C
- 1.01 g/cm³
- EMICODE
- EC1 Plus - very low emissions
- Dilution ratio
- ready to use
- Surface drying
- 2 hours
- Set to light foot traffic
- 2 hours
- Application temperature range
- +5°C to +35°C
Typical values as Mapei prints them in data sheet edition 11016-2-2026 (UAE). They are not a specification for your project: the current Mapei data sheet is.
On site
Packs, mixing and storage.
- We stock
- 1 litre
- Mapei packaging
- UltraCare Stain Protector W Plus is supplied in 1 litre jerrycans.
- Storage
- UltraCare Stain Protector W Plus may be stored for 3 years in its original packaging.
Related products
Tile Adhesives, Grouts & Care.
UltraCare Stain Protector W Plus in Tanzania
Tell us the area. We will quote the job.
Sahihi is an authorized Mapei distributor in Dar es Salaam. Send the quantity of UltraCare Stain Protector W Plus you need, or describe the job and we will work it out with you.