Mapei's own picture. The pack we stock: 585 ml cartridge.
Mapei · Chemical anchorNo. 22 / 47
Mapefix EP 50
Epoxy resin for structural chemical anchor.
Epoxy resin for structural chemical anchor
It is specifically formulated for anchoring threaded components and rebar made from steel and galvanized steel that transmit structural loads into solid substrates such as concrete, lightweight concrete, stone, wood and sound masonry
It is also suitable for anchoring metal bars in tension and compression zones, in cracked or non-cracked concrete
Mapei's own document, unaltered, saved on 2026-11-05. Mapei revises its data sheets: ask us for the current edition before you specify.
Application
Where it is used.
In Mapei's own words, from the technical data sheet.
01It is specifically formulated for anchoring threaded components and rebar made from steel and galvanized steel that transmit structural loads into solid substrates such as concrete, lightweight concrete, stone, wood and sound masonry
02It is also suitable for anchoring metal bars in tension and compression zones, in cracked or non-cracked concrete
03Dolly bars for second pours
04Immersed anchors or in damp environments
05Underwater anchors
06Rails of overhead cranes and tramways
07Safety barriers
08Street guardrails
Where it is not the right product.
Do not use on dusty and crumbling surfaces
Do not use on surfaces which are dirty with oil, grease or stripping compounds, the bonding could be compromised or reduced
Do not apply if the temperature of the air or substrate is lower than +5°C
Do not apply loads until it has completely hardened (Tcure) (see Table 1)
Specification
Technical data.
ETA option 1 · anchors in concrete in tension and compression zones
ETA REBAR · anchors fr supplementary reinforcement
EAD 330499-01-0601 · for anchors
EAD 330087-00-0601 · post-installed rebar
Appearance
thixotropic paste
Colour
light grey
Density
1.50 g/cm³
Application temperature range
from +5°C to +40°C
Start setting time
see Table 1
Complete hardening time
see Table 1
Compressive strength (EN 196-1)
122 N/mm²
Flexural strength (EN 196-1)
66 N/mm²
Modulus of elasticity (EN ISO 527-2)
6,300 N/mm²
Service temperature
40°C to +72°C
Hardness
86 Shore D
Typical values as Mapei prints them in data sheet edition 5810-7-2022 en (IT). They are not a specification for your project: the current Mapei data sheet is.
On site
Packs, mixing and storage.
We stock
585 ml cartridge
Mapei packaging
Boxes of twelve 585 ml cartridges with 12 static mixers with extension tube.
Storage
24 months in their original packaging at a temperature of +5° to +25°C.
Sahihi is an authorized Mapei distributor in Dar es Salaam. Send the quantity of Mapefix EP 50 you need, or describe the job and we will work it out with you.
